Sealant-laying red high-temperature Red LAVR, 85 G

Sealant-laying red high-temperature Red LAVR, 85 G

Quickly forms reliable and tight gaskets for the exhaust system, valve cover, intake manifold, cooling pump, thermostat and gearbox housings, oil pan
Withstands temperatures from -62 to 399°
Polymerizes in 15 minutes
Fully cured at room temperature in 18-24 hours
Resistant to water, gasoline, antifreeze, oils and other technical fluids
Has high adhesion to smooth and rough metal, plastic, rubber surfaces
Does not spread
Retains elasticity after hardening
Does not contain acids and solvents
Does not cause corrosion
Non toxic
Has a neutral odor

Red high-temperature sealant reliably seals thermally loaded components and connections. Replaces rubber, paper, metal gaskets, seals and seals. Made of high quality silicone, the composition retains its properties under the influence of all technical fluids, even in extreme temperature conditions. It is applied to repair of adjoining connections of the engine, transmission and an exhaust system. Suitable for engines equipped with a turbocharger.

Application
Remove old gasket or sealant
Thoroughly clean the surface from dirt and residues of gasket materials
Degrease the treated surface
Pierce the seal of the tube with the upper part of the cap, put on the attached nozzle, cut off the tip of the nozzle
Apply sealant with a layer of 1.5 - 3 mm, allow to dry for 10 minutes and connect the parts to be sealed
Close the tube with a cap after use.