TOTEK MK-02 Complex additive in engine oil 250ml MK02025
Quantity
TOTEK MK-02 Complex additive in engine oil 250ml MK02025
TOTEK MK-02, which, like TOTEK MK-01, increases the flash point of synthetic (hydrocracked) motor oils, which is quite low and insufficient - they begin to “burn” in the engine (subject to thermal degradation). This lack of motor oils is easily determined by opening the engine oil intake cap and smell it. A characteristic burnt pungent odor will signal unfavorable processes occurring in the engine. The smell also indicates that the oil is burning and the strength of the oil film is weakened or absent altogether. One way or another, with this symptom (the smell of burning), it is not enough to resist thermal and mechanical stress in the engine. Engine protection is weakened! Help is urgently needed for such oils, and from the very beginning of their operation, as soon as you have changed the oil. Many in this case were frightened by a significant increase in the base number of fresh oil and they did not dare to use TOTEK MK-01. Now it is possible to fill any fresh oil with TOTEK MK-02. This is an absolutely amazing drug that will change the performance of any motor oil for the better. Products of the MK series will radically change the operation of the oil, adding expensive and high-quality polyalphaolefins and esters to its base.
Engine oil is a recombinant system, the recombination technology was first proposed by Fuel Technologies Corporation, i.e. the principle of the oil constructor is applied. The abbreviations MK in the name of the drug means “oil constructor”, 01 is the serial number of the development. It is planned to release at least five preparations for recombination of oils. Now we bring to your attention 02 - this is the serial number of the second product in this line. In the future, this term "recombination" will be replaced by a more understandable and acceptable one - configuration. We will use TOTEK MK preparations (oil constructor) to change the configuration of oils, as we do (for example) with our computers. In this case, there is no need for a large number of different brands of oil, which complicates and increases the cost of car operation.
Purpose:
TOTEK MK-02 is designed to increase the strength of the oil film of fresh oil, increase its flash point, enhance the antiwear and extreme pressure properties of the oil (tribological characteristics) and the HTHS parameter. The drug helps to increase the strength of the oil film, prolongs its resource capabilities, protects the thickener from premature destruction under the influence of mechanical and thermal loads. Provides enhancement of the working properties of the oil, allowing the vehicle to be operated under increased loads, when driving on the highway at high speed and with a heavy load.
The use of TOTEK MK-02 will not have the maximum expected effect in cases where the engine oil has already lost its protective properties (worn out by mileage> 8-10 thousand km.). If you have no time to change the engine oil in time, and current affairs require you to continue driving a car, it is better to use TOTEK MK-01 in the aged oil.
Mode of application:
Warm up the engine to operating temperature (opening the thermostat), turn off, check the oil level according to the instructions. Open the oil inlet and pour in the TOTEK MK-02 preheated to room temperature at the rate of 50 ml of the drug per 1 liter of fresh motor oil filled into the crankcase of your car engine. Close the oil inlet, start the engine and let it idle for 5 minutes. Stop the engine and let the oil drain into the crankcase and check the oil level. It is best to record all surveillance activities in the vehicle's logbook (if available).
As a result of the natural loss of oil due to its waste caused by the special properties of the oil (low-quality oil or not properly selected for the engine), the design features of the engine or special operating conditions, TOTEK MK-02 can be used as a universal top-up for any type of engine oil up to the required level.
Dosage:
TOTEK MK-02 is produced in plastic bottles made of PET material with a volume of 0.5 l packed in a corrugated cardboard box of 20 pieces.
For use in road vehicles, a dosage of 50 ml per 1 liter of oil is recommended. One bottle for 10 liters of engine oil.
In the case of using the machine in conditions of high ambient temperatures and heavy loads, sports competitions, the dosage can be increased to 100 ml per 1 liter. engine oil.
Compound:
It is made from a mixture of high viscosity, high strength, mechanical and thermal degradation resistant PAO and esters with the addition of antiwear and extreme pressure additives.