Wireless 220V Two Channel Remote Switch for Lights and Equipment

Control two compatible electrical loads from a convenient handheld transmitter. This 220V wireless remote switch pairs a receiver with a remote to provide simple on and off operation without running an extra control wire to your preferred location. Its two output channels allow compatible lamps or devices to be managed independently. Compact and practical, this two channel relay switch suits qualified electrical installations in homes, shops, and workshops.

Key Features

• Two channels provide independent control of compatible loads.
• Wireless transmitter adds convenient operation from a distance.
• Receiver operates from a 220V AC electrical supply.
• On and off controls suit straightforward switching applications.

Why Choose Our Wireless 220V Two Channel Remote Switch for Lights and Equipment

Compared with a single-channel unit, this lamp remote control can manage two separate circuits from one transmitter. It offers a practical solution where installing an additional wall switch or control cable would be inconvenient.

Perfect For

Suitable as an electrical equipment controller for compatible lamps, ceiling lights, signs, fans, and other approved appliances. Load type, starting current, and switching requirements must remain within the receiver’s specifications.

How to Use

Disconnect and verify the mains power is off before installation. Wire the receiver according to its supplied diagram, pair the transmitter if required, then test each channel before regular operation. Installation by a qualified electrician is strongly recommended.

Compatibility and Safety

Confirm the input voltage, output type, maximum resistive and inductive load, wireless frequency, operating mode, and remote range before ordering. Motors and other high-starting-current loads may require an appropriately rated contactor. Install inside a suitable dry, insulated enclosure and follow local electrical codes.

Control Two Circuits with Greater Convenience

Add straightforward wireless switching to compatible lights and electrical equipment with one compact control set.