Additive in engine oil 50 ml Remetal RiMet PT0005

Additive in engine oil 50 ml Remetal RiMet PT0005

ReMETALL is an export version of RiMET, the first Russian remetallizant developed at the Academy of Sciences for in-place increase in the service life of internal combustion engines. The drug has been on the market for more than 20 years and has gained a reputation as a reliable and proven drug among hundreds of thousands of car owners in Russia (RiMET) and abroad (ReMETALL). The preparation contains ultrafine powder of copper-tin alloy (Cu-Sn) with an average particle size of 2-3 microns. Thanks to a special treatment with surfactants, the powder particles do not interact with the oil and with each other and practically do not settle.
REMETALL is recommended for various types of engines of cars and trucks, engines of mobile and stationary power plants of various capacities, compressors and other equipment. The preparations of the RiMET series are compatible and can be used with any type of lubricating oils.
 
Application effect:
- the wear rate is reduced by 30-40%;
- friction coefficient decreases by 2-4%;
- Significantly increases the overhaul mileage and time to overhaul;
- it is easier to start the engine at low temperatures;
- the compression on cylinders is restored and leveled;
- power increases up to 3-5%;
- oil pressure increases;
- reduced fuel consumption, oil and CO content in the exhaust gases;
- the noise level is reduced.

The effect of the drug manifests itself after no more than 600 km of run and persists until the next oil change, but not more than 10-15 thousand km. run.

Mileage, thousand km

Over 60 Over 120 Over 180 Over 300
50 ml     100 ml      150 ml     200 ml
1 bottle   2 bottles   3 bottles   4 bottles

1. Engine preparation
- if necessary, flush the oil system and engine crankcase;
- drain the old engine oil;
- replace the oil fine filter;
- if there is a centrifuge, clean its body from deposits and rinse;
- Fill with fresh engine oil.
  
2. Application of the drug
Filling ReMETALL is recommended immediately before the trip, or immediately after filling, let the engine idle for 10-15 minutes to evenly distribute the particles of the drug throughout the oil volume.

Filling more than 1 cylinder, do it sequentially: first one, then, after a run of 150-200 km, the next cylinder.

- before using the drug, without opening the container, shake it vigorously for 20-30 seconds;

- immediately after shaking, pour the contents of the cylinder into the engine oil through the oil filler neck;

- check the presence of sediment at the bottom of the cylinder, which is allowed if the agitation is not strong enough. In this case, it is necessary to pour a small amount of fresh engine oil into the cylinder, shake the contents of the cylinder again vigorously or mix and pour the suspension into the oil.