RiMET for automatic transmission 100ml For hydraulic automatic transmissions and CVTs PT0129

RiMET for automatic transmission 100ml For hydraulic automatic transmissions and CVTs PT0129

RiMET for automatic transmissions is a preparation for in-place restoration and wear protection of hydraulic automatic transmissions (automatic transmissions), including CVTs. It is a liquid crystal that contains a complex of natural and synthetic catalysts, organic structures and ceramics. Forms nanostructured wear-resistant protective coatings with increased durability on friction surfaces.
For use with any type of hydraulic fluid.
 
Application effect:
- reduces wear rate up to 2 times;
- increases the service life of automatic transmission by 2-3 times;
- eliminates jerks when shifting gears;
- restores and improves the dynamics of acceleration of the car;
- increases the service life of hydraulic fluid by 1.5-2 times;
- improves the operation of the hydraulic system pump and flushes its channels, restoring the working pressure;
- increases the surface strength of the friction discs and increases the coefficient of friction on them;
- protects gears and bearings from wear;
- restores the elasticity of rubber seals, reducing oil leakage (ATF).

A 100 ml package is designed for automatic transmissions with a hydraulic fluid volume of up to 10 liters. When the volume of hydraulic fluid is more than 10 liters, the amount of the drug must be increased in proportion to the amount of hydraulic fluid in the box.

It is recommended to pour RiMET for automatic transmission into fresh hydraulic fluid, or hydraulic fluid, the service life of which does not exceed 50%.

- replace the hydraulic fluid;
- open the vial only after vigorous shaking for 20-30 seconds;
- pour the drug into the hole of the automatic transmission dipstick. Insert the probe into place;
- start the engine;
- press the brake pedal, and while holding it, turn on the gear "R" for 5-10 seconds, then the gear "D" for 5-10 seconds, also turn on all other gears for 5-10 seconds;
- repeat this switching cycle 3 times, after which you can start using the car in normal mode.