RiMET Healer Motor NEW 100ml PT0021
Quantity
RiMET Healer Motor NEW 100ml PT0021
Motor Healer is an export version of RiMET NANO - third generation remetallizer. The copper-tin-antimony (Cu-Sn-Sb) ternary alloy powder has a nanodispersed fraction with particle sizes less than 1 μm. During the operation of the engine, its smallest particles easily fill the smallest defects formed on the contact surfaces. In addition, the drug contains a complex of additives designed to increase engine power.
Application effect:
- increases engine power up to 20%;
- wear rate is reduced up to 70%;
- the coefficient of friction is reduced to 8%;
- increase overhaul run and engine life up to 3 times;
- reduced fuel consumption up to 8%;
- oil consumption is reduced up to 15%;
- it is easier to start the engine, especially at low temperatures;
- the compression on cylinders is restored and leveled;
- oil pressure increases;
- the noise level is reduced;
- the content of CO in the exhaust gases decreases.
The effect of the drug manifests itself after no more than 200-300 km of run and remains until the next oil change, but not more than 10-15 thousand km of run.
Mileage, thousand km
Over 60 Over 120 Over 180 Over 300
50 ml 100 ml 150 ml 200 ml
0.5 bottles 1 bottle 1.5 bottles 2 bottles
To prevent wear, fill in 0.5 cans (50 ml) with each oil change, for an oil system volume of 3-5 liters
Maintenance dosage after recovery, at the following oil changes: 0.5 bottle (50 ml) per 3-5 liters of oil
1. Engine preparation
- if necessary, flush the oil system and engine crankcase;
- drain the old engine oil;
- replace the oil fine filter;
- if there is a centrifuge, clean its body from deposits and rinse;
- Fill with fresh engine oil.
2. Application of the drug
Filling Motor Healer is recommended immediately before the trip, or immediately after filling, let the engine idle for 10-15 minutes to evenly distribute the drug particles throughout the oil volume.
Filling more than 1 cylinder, do it sequentially: first one, then, after a run of 150-200 km, the next cylinder.
- before using the drug, without opening the container, shake it vigorously for 20-30 seconds;
- immediately after shaking, pour the contents of the cylinder into the engine oil through the oil filler neck;
- check the presence of sediment at the bottom of the cylinder, which is allowed if the agitation is not strong enough. In this case, it is necessary to pour a small amount of fresh engine oil into the cylinder, shake the contents of the cylinder again vigorously or mix and pour the suspension into the oil.