TRANSPARENT EPOXY GLUE IN SYRINGE 25 ML ABRO MASTERS ec330re

TRANSPARENT EPOXY GLUE IN SYRINGE 25 ML ABRO MASTERS ec330re

Description:
two-component transparent epoxy adhesive in a syringe.

Scope of application:
Designed for home and car use. Bonds metal, concrete, fiberglass, glass, ceramics, porcelain, rubber, wood and most plastics.

Properties:
• instantly seizes in 5 minutes;
• provides high durability;
• waterproof;
• remains transparent after drying;
• resistant to detergents and most solvents;
• Easy to use thanks to convenient and uniform dosing.

1. The surfaces to be bonded must be clean and dry. Adhesive application temperature from +5° to +45°.
2. Remove the plastic fuse located between the pistons.
3. Break off or cut off the tip on the syringe tips and use it later as a cap.
4. Hold the syringe vertically with the spouts up and wait for the air bubbles to rise. Release excess air.
5. Squeeze equal amounts of resin and hardener into the plastic mixing container provided or onto any clean surface. Press the plunger back, wipe the tips and close the syringe with a cap.
6. Thoroughly mix the components with a spatula until smooth. Use the finished composition within 3 minutes.
7. Apply the compound and squeeze the surfaces to be bonded for 15 seconds. Setting time: 5 minutes. The glued item can be used after 15 minutes. Full hardening occurs after 1 hour.

Not recommended for use above 93°C.
Low temperatures slow down the curing time of the adhesive.
It is not recommended to use on polyethylene and polypropylene, as well as on surfaces in contact with food and permanently immersed in water.