Toy Face embroidery design

 

1.50” X 0.96”  (38.2 mm X 24.4mm) 731 st

1.73” X 1.11” (44.0mm X 28.2mm) 850 st

2.00” X 1.28”  (50.8mm X 32.4mm) 1044 st

2.23” X 1.43”  (56.6mm x 36.2mm) 1184 st

2.48” X 1.58” (63.0mm X 40.2mm) 1373 st

2.73” X 1.74” (69.4mm X 44.2mm) 1566 st

3.00” X 1.91” (76.2mm X 48.6mm) 1805 st

3.25” X 2.07” (82.6mm X 52.6mm) 2032 st

3.50” X 2.23” (89.0mm X 56.6mm) 2279 st

3.75” X 2.39” (95.2mm X 60.6mm) 2526 st

3.97” X 2.53” (100.8mm X 64.2mm) 2742 st

4.23” X 2.69” (107.4mm X 68.4mm) 3024 st

4.48” X 2.85” (113.8mm X 72.4mm) 3302 st

4.73” X 3.01” (120.2mm X 76.4mm) 3594 st

4.94” X 3.17” (126.4mm X 80.4mm) 3884 st

 

The following 9 formats are included in the file you will receive:

 

* DST - (Tajima)

* EXP - (Melco)

* HUS - (Husqvarna,Viking)

* JEF - (Janome,Elna,Kenmore)

* PES - (Brother,Deco,Babylock)

* SEW - (Janome,Elna,Kenmore)

*VP3 - (Husqvarna,Viking)

*VIP

 

Please note this is NOT a patch or a physical item. This is an embroidery design. You will need an embroidery machine to stitch these designs out.

 

**************************************************************************************************

You MUST have an embroidery machine and the software needed to transfer it from your computer to the machine to use this file. This listing is for the machine file only - not a finished item.

******************************************************************************************

 

For a quality stitched design, I recommend using proper stabilizer and needle size for the project fabric along with quality thread. In particular, with fine gauge and knit fabric, such as T-shirts and baby onsies, I find it best to use a sticky back stabilizer on the fabric with a stitch and tear stabilizer on top of it inside the fabric AND a wash away stabilizer on the outside of the fabric, especially when stitching fonts or thin lines. A thinner gauge knit needle can prevent needle holes as well.