220 volt/ 100 Watt Scraping Hot Wax Uncapping/Decapping electric knife "Jointer"

**SUPPORT ONLY 220-230V EU plug**

!!! WHO WANT USE THIS DEVICE IN 110-120V NEED AC VOLTAGE CONVERTER, NOT WORK IN USA AND CANADA !!!

Description:

    For many years up to this day, in order to cut the seals knife heated in hot water. At the same time it had to maintain a high temperature of the water and occasionally warm in her knives.But those days are long gone, replaced by bee came electrotome "jointer". Using this blade, undoubtedly several times faster and easier preparation of cells for pumping honey. The power of knife is  100 watts it's allowing it to warm up to a temperature of 150 ° C / 302 F
     "Jointer" Knife - is designed for printing with honey and honeycomb for cutting wax. The blade of the knife is located across the line of motion and the lid is very clean cut off a sharp blade.
     "Jointer" Knife is very easy to use, especially who have to pump out the honey with a large number of frames. Pump out the honey from the frames printed with this knife has less wax and the filter will clog less often.

Specifications:

Power supply: 220Volt EU plug (± 10%, 50Hz)
Heater power:  100 watt
Working temperature of knife blade: not less than 150° / 302 F
Warm-up time to operating temperature : 10-15 min
Energy protection class: II

Dimensions:

Blade width : 11 cm (4,33 inch)
Blade height : 3 cm (1,18 inch)
Handle length with casing : 30 cm (11,81 inch)
Handle diameter : 2.5 cm (0,98 inch)
Cord Length: 150 cm (59 inch)
Weight: 380 gram

 Manual:

   1) Before you begin, print a frame must be installed on the stand to cut cellular framework (see stand for cutting cellular framework sided and double/sided), under which must be trimmed capacity to collect wax. Turn the device on to 220V supply voltage and wait for 15 minutes to heat the blade to working temperature.
   2) Then proceed directly to the printing frame, and the blade unit are from top to bottom. Removable wax twists and falls into the container.
   3) After processing one side of the frame to start printing the other side of it. In the same manner, the next frame process. (knife is located at a right angle to the handle of the product, which ensures convenience in work - the arm does not get tired)
   4) Heated instrument should only be placed on a special stand, Which it is desirable to fix to the working table with screws
   5) After the work is finished, it is necessary to disconnect the electric knife from Power supply, Place on a stand, allow to cool until completely cooled
   6) Operating mode: 4 hours of work; 0,5 hours - cooling

Included:

1 x 220V/100W  electric decapping knife "Jointer"
1 x English manual