Oil additive Rimet-Nano 50ml PT0011

Oil additive Rimet Nano  50ml PT0011

RiMET NANO is a third generation remetallizer. The copper-tin-antimony (Cu-Sn-Sb) ternary alloy powder in RiMET NANO contains a nanodispersed fraction with particle sizes less than 1 µm. During the operation of the engine, its smallest particles easily fill the smallest defects formed on the contact surfaces. In addition, the drug contains a complex of additives designed to increase engine power.
 
Application effect:
- increases engine power up to 20%;
- wear rate is reduced up to 70%;
- the coefficient of friction is reduced to 8%;
- increase overhaul run and engine life up to 3 times;
- reduced fuel consumption up to 8%;
- oil consumption is reduced up to 15%;
- it is easier to start the engine, especially at low temperatures;
- the compression on cylinders is restored and leveled;
- oil pressure increases;
- the noise level is reduced;
- the content of CO in the exhaust gases decreases.

The effect of the drug appears after no more than 200-300 km of run and persists until the next oil change, but not more than 10-15 thousand. km of run.

Mileage, thousand km
Over 60   Over   120   Over 180   Over 300
50 ml      100 ml      150 ml      200 ml
1 bottle    2 bottles    3 bottles    4 bottles

To prevent wear, fill in 1 bottle (50 ml) with each oil change, for an oil system volume of 3-5 liters

Maintenance dosage after recovery, at the following oil changes: 1 bottle (50 ml) for 3-5 liters of oil

1. Engine preparation
- if necessary, flush the oil system and engine crankcase;
- drain the old engine oil;
- replace the oil fine filter;
- if there is a centrifuge, clean its body from deposits and rinse;
- Fill with fresh engine oil.
  
2. Application of the drug
Filling RiMET NANO is recommended immediately before the trip, or immediately after filling, let the engine idle for 10-15 minutes to evenly distribute the drug particles throughout the oil volume.
   
Filling more than 1 cylinder, do it sequentially: first one, then, after a run of 150-200 km, the next cylinder.

- before using the drug, without opening the container, shake it vigorously for 20-30 seconds;
   
- immediately after shaking, pour the contents of the cylinder into the engine oil through the oil filler neck;

- check the presence of sediment at the bottom of the cylinder, which is allowed if the agitation is not strong enough. In this case, it is necessary to pour a small amount of fresh engine oil into the cylinder, shake the contents of the cylinder again vigorously or mix and pour the suspension into the oil.